Motives Why a Hot Water Tank Will Explode

Posted by on Jan 22, 2015 in Gas Water Heater Repair Carrollton TX, Water Heater Repair Carrollton TX, Water Heater Safety

With regards to needing to perform servicing on ones water heater, it is a relatively minimal maintenance home appliance.  Nevertheless, one important aspect of it ought to be checked out routinely.  Water Heater Repair Carrollton TX would like to pass on this safety material regarding ones water heater today.

Extreme temperature if coupled with tank deterioration inside the storage tank could cause an explosion. Any time the water temperature is less than 212 degrees Fahrenheit, one is going to be secure from an explosion, though there is a threat of scalding at that temperature.  However, if the water temperature is over 212 degrees, water changes into steam, which will enlarge to 1,700 times the space it takes up as water. This is the time an explosion can happen.

Cautionary Signals of a Water Heater ExplosionHot Water Heater Repair Carrollton

The leading sign is if one goes to get hot water from a faucet and only steam comes out.  Without delay shut off electric power if one owns an electric water heater.  If one owns a gas hot water heater, shut off the gas valve on the water heater.  Next, give us a call to come examine the condition.

Minimizing Potential Water Heater Dangers

The most significant upkeep endeavor having a water heater is to check the pressure relief valve, also referred to as the T&P valve, on a standard schedule.   This valve helps manage the pressure accumulation on the interior of the water storage tank to avoid a hazardous increase in temperature and overpressure.

Caution!
Be careful, the water release with a T&P valve is often rather hot. If you do not feel at ease examining the valve inform us.  Additionally, performing any sort of fixes to the valve should really be completed by a specialized plumbing repair business.

How to Test the T&P Valve

Clear the space close to the overflow pipe and floor drain.
Raise the test handle for about 5 seconds or until the water runs clean.
Let go of the handle.
If the T&P valve keeps on running with water, lift up the handle up and down rapidly to have it reseat itself.  One might have to do this a handful of times.  IF it has not been tested for a while, it might be difficult to raise it at first.  Avoid using an excessive amount of force, however might need to utilize just a little.
If the T&P valve continues to leak, it should really be changed.

Some other items to watch out for are deterioration on the stem of the valve.  If there is any water dripping out of the valve stem or out of the drain valve.

Interested in far more suggestions?  Look at Water Heater Repair Carrollton’s additional articles right here:

Carrollton Water Heating Savings Advice

Heat Loss Prevention With Water Heater Blankets

From around the Web:

The Aquanta smart water-heater controller promises to slash your energy bill

Home maintenance checklist: Fall